Torch Down Roofing System
Torch down roofing (or modified bitumen) is widely used for roofing on flat roofs. Its name is derived from the method of torching the bitumen sheets onto a fiberglass base during installation. The material used in the torch down process is also know as rubberized asphalt. Melting of the bitumen by torching creates a strong and consistent seal which makes torch down roofs long- lasting. The roofing torch down method is generally regarded as preferable to the alternative method of BUR roofing systems using hot tar. There are no noxious fumes associated with torch down roofing installation, and torch down roofs are regarded as more durable and resistant. The high quality resins that are combined with the modified bitumen in torch down roofing installation also help to provide protection from UV rays that could otherwise provide damaging.
RESIDENTIAL AND COMMERCIAL ROOFING SYSTEMS
Choosing the right roofing system can be very frustrating without the proper guidance. Our roofing contractors out state certified and have a very extensive knowledge in there trade. They can assess you current roofing systems and give you a wide range of options to choose from to point you in the right direction.
Ph: 786-523-3773
Fax: 786-523-0633
Email: Info@HardtopRoofing.com
Hours of Operation: Mon-Friday 8am-6pm
Single Ply Roofing System
Unlike built-up roofing, single ply roofs are just that – one layer of roofing material as a waterproofing membrane and a weathering surface. Single ply roofing membranes are much thinner and lighter than built-up roofs. Single ply roofing is used in both residential and commercial roofing. Single ply roofs are typically installed either in fully adhered (glued to the insulation or fiber board bellow it) or mechanically attached to the roof deck with corrosion resistant fasteners and barbed plates. Most common single ply roofing systems today are EPDM Rubber roofing and TPO roofing systems (thermoplastic polyolefin).
Modified Bitumen SA Roofing System
Self adhered roofing systems have been gaining popularity due to there durability and clean installation. These roofing systems are both used on residential roofing systems as well as commercial roofing systems. Most SA systems are installed with three layers of protections providing the protection of a BUR roof system with the durability of a modified torch down system. Modified Bitumen SA roofing systems are a little bit more expensive but worth every penny
Licensed & Insured
CCC1328894
Metal Roofing System
Metal, primarily thought of as a low-slope roofing material, has been found to be a roofing alternative for home and building owners with steep-slope roofs. There are two types of metal roofing products: panels and shingles. Numerous metal panel shapes and configurations exist. Metal shingles typically are intended to simulate traditional roof coverings, such as wood shakes, shingles and tile. Apart from metal roofing’s longevity, metal shingles are relatively lightweight, have a greater resistance to adverse weather and can be aesthetically pleasing and have Class A fire ratings.
Low Slope Roofing Systems
BUR Roofing System (Built up roofing)
The name says it all. This roofing system is built up using multiple layers normally consisting first of a 75 lb base sheet either nailed or mopped to the roof deck depending on the deck type. Second two plies of GAF Ply 4 fiberglass are hot mopped over base sheet with hot asphalt. Last but not least a mineral surface cap sheet or mineral surface modified bitumen is mopped over the fiberglass using hot asphalt. Insulation is optional, but if are installing over a concrete roof deck it is recommended to prevent blistering. There are many different Miami-Dade County approved application methods as well as different types of material that can be used when building up a roof the one listed above is the most commonly used in Miami and Broward County for more information
Steep Slope Roofing Systems